(Edit: I always forget that Beehaw will convert every ampersand character in code segments to &. Have this in mind when reading the code below. Do you have these problems too with your instance?)

If you update your system from terminal, do you have a shortcut that bundles bunch of commands? I’m on EndevourOS/Arch using Flatpak. Rustup is installed and managed by itself. The empty command is a function to display and delete files in the trash using the program trash-cli. In my .bashrc:

alias update='eos-update --yay \
    ; flatpak uninstall --unused \
    ; flatpak update \
    ; rustup update \
    ; empty'

empty() {
    trash-empty -f --dry-run |
        awk '{print $3}' |
        grep -vF '/info/'
    trash-empty -f
}

I just need to type update. Also there are following two aliases, which are used very rarely, at least months apart and are not part of the main update routine:

alias mirrors='sudo reflector \
        --protocol https \
        --verbose \
        --latest 25 \
        --sort rate \
        --save /etc/pacman.d/mirrorlist \
    && eos-rankmirrors --verbose \
    && yay -Syyu'

alias clean='paccache -rk3 \
    && paccache -ruk1 \
    && journalctl --vacuum-time=4weeks \
    && balooctl6 disable \
    && balooctl6 purge \
    && balooctl6 enable \
    && trash-empty -f'

This question is probably asked a million times, but the replies are always fun and sometimes reveals improvements from others to adapt.

  •  The Doctor   ( @drwho@beehaw.org ) 
    link
    fedilink
    English
    12 months ago

    It’s not that. It’s not getting complacent by eliding the semantics of what you’re doing. It’s being consciously aware that you’re doing something that could possibly fuck stuff up.

    • In fact typing these commands by hand all the time won’t save you from a fuck stuff up anyway. The update-alias is the exact same command I would have typed. In fact, as an alias its less likely to make a typo and fuck stuff up. I’m doing this since 2008, when I started with Linux, and named it always “update”.

      Using the update command I’m always aware it changes the system. Not at least because I also often expand the alias to its full command with a shortcut (update will be replaced in the terminal with the actual commands), I also see what the output of the commands. And without my password it wouldn’t do any system changes anyway.

      So typing these commands everything out won’t be safer, as you suggest.