I have a cheap MechanicalEagle Z-77 keyboard.

I’d like to replace the wired USB A cable with a USB-C port.

when I open it up, I see the cable is attached like this, with wire colors from the top: red white green black black:

When unclipped, I have this, the 5 pins being labeled “S GN D D VD”:

I find some tutorials about how to do a similar job with soldering. I don’t know how to solder and there is a clip. Can I purchase a USB-C port that will clip into this?

I can’t figure out the name of what this component would be called.

I see some mentioning about resistance and capacitors. I don’t know about these things. What if anything do I need to find out? I don’t know if the info in the soldering tutorials applies the same?

Obviously I am very novice on this topic. If I am missing anything please advise and I will attempt to fill it in.

Here is same device on amazon: https://www.amazon.com/Mechanical-Keyboard-Tenkeyless-Professional-Office-Black/dp/B07ZH7569D

Thank you!

  •  Radiant_sir_radiant   ( @Radiant_sir_radiant@beehaw.org ) 
    2•9 months ago

    To find a matching connector you’d normally measure the distance between the pins, at least within the same family of connectors. In this case there are so many similar yet subtly different connectors though, I’m not sure you’ll find the correct one. At any rate, soldering would probably be easiest (even if it’s just aoldering the wires together).

    There may be another approach though. With this type of connector, the pins are normally crimped onto the wire and then stuck inside the plastic case. You could buy a few connectors that look like they might fit, remove the pins (use a small tool such as a 0.5mm screwdriver) and try inserting the pins into the case of the original connector in the correct order.

    Edit: the thick black wire (original) and the grey one (USB-C connector) should be the same.