• TehPers ( TehPers@beehaw.org ) 
    link
    fedilink
    English
    arrow-up
    1
    ·
    35 minutes ago

    If you absolutely refuse to get new fans, you might want to consider creating simple heat pipes to connect to your CPU’s die. Then, create your own giant fin array attached to those heat pipes to passively cool them. You’ll pretty much want to maximize surface area with your fins, so it’ll take forever to make unfortunately.

    Or you could throw a desk fan next to the laptop and see if that works I guess.

    Edit: I should add that this won’t work at all, by the way. You’ll really want a vapor chamber clamped to that die, ideally with liquid metal TIM. You’ll also need proper heat pipes (which are actually somewhat hollow but have a specific design in the middle) and an enormous fin array that’s far larger than what you probably want to make.

    • Lyrial ( lyrial@lemmy.sdf.org ) OP
      link
      fedilink
      arrow-up
      3
      ·
      6 hours ago

      They are only in the parts touching the bottom. I don’t even truly understand it myself, but physics says if you but a large heat sink under something like that, it forces cool air into it. Phlogiston or something, I’m not Greek or a physicist

      • Kache ( Kache@lemmy.zip ) 
        link
        fedilink
        arrow-up
        1
        ·
        2 hours ago

        It’s not sufficient to “just touch”. Correct computer hintsink installs involve smooth, clean, flat surfaces of copper/aluminum, thermal paste, securing snugly with fasteners, etc.

    • Sneezycat ( sneezycat@sopuli.xyz ) 
      link
      fedilink
      English
      arrow-up
      3
      ·
      8 hours ago

      95ºC is uncomfortably hot, and it can reduce your CPU’s life a bit, but I’d say it’s an acceptable risk in some situations. Above 100ºC is when I get really unsettled, and wouldn’t want my hardware to do it for more than a few seconds. Going above 110ºC sounds like it will cause degradation really fast, you never want to get that high.

      If you want your PC to have a long life, you should strive to never pass 85ºC or so.

      • wicked ( wicked@programming.dev ) 
        link
        fedilink
        arrow-up
        4
        ·
        7 hours ago

        Will CPU lifespan or stability be affected under high temperature?

        Intel

        As long as the temperature is lower than the original standard (105 or 100 Celsius degrees) regulated by Intel, the CPU lifespan will not be affected. The CPU has its own protection system/mechanism. When the core temperature exceeds the set temperature, the power will be reduced to maintain a safe temperature.

        AMD

        AMD’s engineering team has repeatedly stated that, when PBO or PB is enabled, the processor’s boosting algorithm is designed to maximize performance within the limits of the cooling solution available. As long as the processor remains below its hardware-defined thermal threshold (Tjmax, typically around 100°C to 105°C depending on the processor model), it will continue to opportunistically pursue the highest possible performance. The processor incorporates highly sophisticated and stringent protection mechanisms, ensuring that temperature fluctuations within AMD’s official operating specifications have no adverse effect on processor longevity or system stability.

        Pretty sure you’re wrong about that. Personally I’ve never had a CPU fail except the machine that ran it hotter than 110, but that was twenty years ago, and I regularly run my machines for years, and I see them throttle and stay under 100 degrees now.

        • Lyrial ( lyrial@lemmy.sdf.org ) OP
          link
          fedilink
          arrow-up
          4
          ·
          7 hours ago

          The machine will run at those temps, but the performance is likely to be very low via throttling (hitches in frames etc.). If your system is running that hot, you should look into better cooling.

          • wicked ( wicked@programming.dev ) 
            link
            fedilink
            arrow-up
            2
            ·
            7 hours ago

            Almost all my machines are laptops which I move around frequently, so better cooling isn’t easy. Throttling in some way, ie. by letting the CPU thermal throttle or running less stuff, or less demanding stuff, is my only way to reduce temps usually. They’re usually locked down in terms of changing voltage myself too, unfortunately. But again, running them at 100 degrees basically constantly hasn’t ever caused any problems for me.