Specifications:
- Full size (80ish+ size with a reduced numpad will also work)
- ISO key layout (as in, a proper Return key. ANSI can burn)
- Numpad
- Wireless (if possible)
- Don’t need any RGB
- I don’t care about keycaps, so any leftovers will do. They don’t even have to be representative of the actual key, random letters and symbols will be fine, even duplicates
When I wasbinto RC Helicopters i liked flying, but didn’t get much entertainment feom building. This other guy liked building but didn’t care that much about flying. I was hoping to run into someone similar here.
EDIT: The helicopter sory as I posted it elsewhere, in case anyone cares. https://lemmy.ml/comment/2517850
Look at Keychron. Wide selection of boards. Pretty solid build quality and reasonably priced!
Second this. I was so happy I bought a second one for work.
i think you might overestimate the building part.
If you get a barebones board with a hotwap PCB you have to screw in stabilizers for all keys larger than 2u (=2 keys) - Shift, Enter, Backspace and Space. Since you can’t be arsed, screw lubing them. Just screw them in, takes 3 minutes.
Then, place all the switches on Plate and PCB and since they’re hotswap you just press them in.
Then place like 8 gaskets or screws, drop on your PCB-Plate-Switch-Sandwitch, screw together top and bottom with 4 more screws.
When you’re done, mount the caps, also just pop them in place.
That’s it. I reckon it’s about as much work as a 10$ Lego set.
But going prebuilt is far easier of course: Unpack, plug in, done. If you get a hotswap you can change switches later on if you fancy.
MX mechanical support ISO and fullsize as well
Keychron has the K10 (full size) and K13 (TKL footprint with most of the numpad) in wireless ISO.




